The hole should now be 1-2mm from the target size.DO not full force the bit into the plastic as the forces could damage the enclosure Carefully and slowly drill the hole with light passes, off and on.Align the drill bit to the center of the slide stick hole.Use a church key to swap the drill press bit with a 13mm Drill Bit.The rubber membrane will prevent vise marks being imprinted on the plastic. Place The Front Panel in the Bolted Vise on the Drill Press with the contact points with the vise covered in paper towels or a rubber membrane.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |